Inspecting Incoming Components Before Assembly
Counterfeit breakers and damaged drives are found in ten minutes or in the first week of production. What to check.
202503-21
Crimp Tool Calibration and Its Cost
One tool out of calibration fails one terminal in five hundred. Multiply by a year of production and the maths is clear.
202503-18
Reading a Cable Schedule Correctly
Core count, screen, voltage grade and route. Four columns that are misread on almost every first enquiry.
202503-15
Insulation Resistance Testing: Values and Limits
What 500 V DC proves, what it does not, and the reading that should stop a panel leaving the workshop.
202503-12
Continuity Testing Every Terminal
Point-to-point checking against the drawing catches the wire that was landed one terminal off. It takes hours and saves days.
202503-10
