Crimp Tool Calibration and Its Cost
Crimp tool calibration is invisible work. One tool out of calibration fails one terminal in five hundred, which means the failure appears at random in panels that were otherwise built correctly.
How often
Every six months for hand tools in daily use, and after any drop. ratchet tool that has been dropped usually still ratchets but no longer reaches full crimp height. The check is a pull test on five samples with a calibrated force gauge, or a crimp height measurement with a micrometer against the tool's specification.
What goes wrong
Wrong die for the ferrule size, worn die faces, a ratchet that releases early, and a tool shared between two benches where nobody owns the calibration. The last is the most common: a tool with no owner has no calibration.
Making it stick
Tag each tool with its calibration date, keep one spare, and record the pull test in the same log as the panel tests. The ferrule note covers the crimp standard itself, and the custom control panel is wired with tools that are on a documented calibration cycle.
