Torque Control on Terminal Screws
Terminal screws have a torque range, and both ends of it are failure modes. Too little and the joint heats; too much and the terminal cracks or the thread strips, leaving a connection that looks tight and is not.
The numbers exist
Every terminal manufacturer publishes a torque — typically 0.5 to 0.6 Nm for a 2.5 mm² spring or screw terminal, 2 to 3 Nm for a 16 mm² lug, and 15 to 20 Nm for a large busbar bolt. Those figures are on the terminal datasheet and in the panel drawing notes. Writing them on the drawing is the only way they reach the person with the screwdriver.
Tools and calibration
torque screwdriver with a visible scale, checked every six months against a torque tester. tool that is 30 % out of calibration produces either loose or cracked joints across a whole batch, and neither is visible on inspection.
Marking
Mark checked terminals with a paint pen after torqueing. The mark is fast, visible and impossible to fake — a second person can see at a glance which terminals have not been checked. The ferrule note covers the conductor end, and the custom control panel is delivered with torque values on the drawing and marked terminals inside the panel.
