News
N

News

News

New Fibre Laser Cell Cuts Enclosure Openings in One Pass

Column: Company News    Time: 2026-07-08

Second fibre laser went into the sheet metal bay this month, next to the first one installed three years ago. The two machines now cover every opening in a cabinet — doors, gland plates, mounting plates, DIN rail slots and the cut-outs that used to need a punch and a file.

What the second machine replaced

Two turret punches, both over fifteen years old. They were reliable and slow: every new door pattern needed a tool change, and a one-off design meant an hour of setup before the first cut. For repeat work they were fine. For the custom panels that make up most of our order book they were the bottleneck.

Fibre laser does not care about batch size. The nesting programme runs from the DXF, the sheet goes on the bed, and the first part comes off cut to finished size. Changeover between two different door patterns on the same sheet now costs nothing beyond the nesting time.

Changeover on a one-off door, measured

We timed the same part on both machines before retiring the punches. Door with a 180 × 320 mm window, four mounting holes, two hinge slots, 1.5 mm cold-rolled steel:

StepTurret punchFibre laser
Tooling / programme setup38 min3 min
Cutting4 min2.5 min
Deburr and edge finish6 min1 min
Total for one part48 min6.5 min

On a batch of two hundred identical doors the punches were competitive, because setup was amortised. Below about twenty parts the laser wins decisively, and most of our work is below twenty.

What it changes for customers

  • Small custom orders stop paying a setup premium. Cutting one panel to a new drawing no longer carries a tooling charge, so a single prototype is priced like a small batch.
  • Drawing revisions are cheap before cutting. Changing a cut-out on the approval drawing costs a nesting change, not a new tool.
  • Consistent edge quality. Cut edges come off clean enough to go straight to pretreatment, which removed a manual deburr step from every panel and with it a source of scratches.
  • Nesting across a batch. Parts for two different orders can share one sheet when the material and thickness match, which reduced our scrap offcut volume noticeably in the first month.

What stayed the same

Nothing downstream changed on purpose. Bending, welding, pretreatment, powder coating and assembly run in the same sequence with the same people. The laser only removes waiting time at the front of the process — which is where the delay used to be for anything non-standard.

Accuracy is quoted at ±0.1 mm on 1.5 mm sheet, which is comfortably inside what the press brake and the hinge positions need. We still check the first part of every new programme against the drawing before running the rest of the sheet.

What is next

Tube cutting is the remaining manual operation in the frame bay, and the current machine cannot take it. We are looking at a combination cell that cuts sheet and tube on the same bed, which would remove the last hand-finished step before welding. No decision has been made yet; the priority this year is throughput on the panel orders already booked.

More News