News
N

News

News

Powder Coating Line Rebuilt for Larger Cabinet Sections

Column: Company News    Time: 2026-05-06

Powder coating line was rebuilt over six weeks this spring. The pretreatment tanks and the curing oven were resized to take a 2.2 m cabinet section in one pass, which removed a two-part painting sequence we had lived with since the workshop opened.

Why it had to change

Anything longer than 1.6 m used to be painted in two operations: lower half through the line, then the section turned and the upper half coated. The overlap zone took two coats and the join was visible on a finished door — most obviously in light colours, exactly the RAL 7035 and 7038 greys that most plants order.

Besides the appearance, two-coat overlaps are difficult to keep inside a film thickness specification. Paint build at the overlap ran 30 to 40 µm heavier than the rest of the panel, and heavy film is brittle film. On a door that flexes when it is opened, that is where the coating cracks first.

What was replaced

  • Pretreatment. Three-stage to five-stage, with the tank length increased to suit the longer sections and a rinse after the conversion coat.
  • Oven. Curing tunnel extended and burner capacity raised, holding 180 to 200 °C for the full residence time on a 2.2 m section.
  • Conveyor. Heavier chain and a wider hanger spacing, so long sections run without sagging between hooks.
  • Booth. Two automatic guns added either side of the manual stations, which halved the spraying time on a full cabinet shell.

The line now takes sections up to 2.2 m by 1.2 m, up to 120 kg per hanger.

What it changes on a finished panel

The visible change is that a large cabinet is now a single colour from top to bottom, with no overlap band on the door or the side panel. The measurable changes:

PropertyBeforeNow
Film thickness, flat areas70 – 110 µm, variable80 – 100 µm, controlled
Coats on a large sectionTwo, with overlapOne
Salt spray, scribed panel480 h720 h
Throughput, cabinet shells per day2235

Salt spray is tested on a scribed test panel to a standard we have used for years, not on a production part. It is a relative indicator of pretreatment quality; the number that matters on site is how the coating behaves where it has been cut or scratched.

What the rebuild cost us in disruption

Five weeks of outsourced coating, which is the honest part of this story. Outsourcing meant we lost control of the pretreatment bath and saw two batches come back with a slightly different gloss on the same RAL number. Both were re-shot at our cost when the line came back up, and both would have gone unnoticed on a single sample panel.

Lesson worth passing to anyone specifying a colour: ask for the RAL number and a physical sample card from the batch your panels will be coated with, not just a digital swatch. Gloss level varies 5 to 10 units between suppliers on the same RAL and it is obvious when two panels stand side by side.

Where this shows up for customers

Large floor-standing cabinets — the ones that used to be split — are now cheaper and faster to make, because one pass through the line replaced two. Lead time on a 2 m cabinet shell dropped by four working days. Colour consistency across a multi-panel order is tighter, since every shell in the batch goes through the same bath on the same day.

More News