News
N

News

News

Interlocks on a Multi-Pump Vacuum Set

Column: Technical Notes    Time: 2025-06-05

vacuum set with three pumps looks straightforward until the interlock logic is written down. Start order, rotation, and the question of whether one failure stops all pumps are decisions that belong on the drawing.

Start order and rotation

Start the pumps in sequence with a delay between each, so the incoming supply is not hit by three simultaneous motor starts and the vacuum vessel is not shocked by a sudden change in flow. Rotate the lead pump each week or each run so wear is even — a simple hour counter and a first-on rotation in the PLC does it.

The interlock that stops everything

Loss of seal water on one pump stops that pump. Loss of cooling or a high vessel pressure stops all of them. Getting this wrong in either direction is costly: stopping all pumps for a single seal water fault shuts down the process for no reason, while continuing with a high vessel pressure can damage the process upstream.

Failure mode on paper

Write out every input and decide what it stops. That table is more useful to the site engineer than the schematic. The liquid ring note covers the seal water protection, and the vacuum pump control cabinet is delivered with the interlock table printed and taped inside the door.

More News

WhatsApp +852 6174 0278WhatsApp +852 6177 3422