Powered Function Test Before Packing
Panel that has never been energised is a prototype, however carefully it was wired. The function test is where the design, the program and the wiring meet for the first time.
What the test covers
Every input simulated, every output observed, every interlock proven, every alarm raised and reset, and every mode of operation run through. For a drive panel, that means running the motor at several speeds and confirming direction, ramps and stops. For a PLC panel, it means forcing each input from the field side and watching the output at the terminal.
What is recorded
test sheet with the serial number, date, tester, and a line per function: expected result, actual result, pass or fail. For drives, the parameter set version and the measured current at each speed. The sheet goes in the door pocket with the drawings.
What is not covered
Site conditions — supply voltage, earth quality, cable length to the motor. The function test proves the panel, not the installation. The site commissioning note covers the rest, and the custom control panel is function tested with the actual program and the customer's I/O list loaded.
