News
N

News

News

Plywood Case Design for Panels

Column: Company News    Time: 2025-02-11

plywood case is a structural component, not a box. It has to carry the panel's weight through a forklift, a container and a crane, and it has to do it while protecting paint that a fingernail can mark.

Base and bracing

18 mm plywood minimum for the base, with bearers at 400 mm centres and skids that allow a forklift to enter from two directions. The panel is bolted to the base through its plinth, not resting on foam. Sides of 12 to 15 mm with corner battens, and a lid that is removable without tools.

The gap

At least 50 mm between the panel and the case wall on every side, filled with foam at the contact points only. panel touching the case transfers every impact directly to the paint. The top gap allows the lid to be removed without striking the panel.

Marking

Weight, dimensions, centre of gravity, this-side-up arrows and the panel serial number on two faces. Where the case will be opened on site with a crowbar, a note showing where to pry saves the paint. The moisture barrier note covers what goes inside, and the custom control panel export packing is designed per panel size rather than from a standard carton.

More News