304 or 316 Stainless: A Coastal Specification
Stainless steel is specified for corrosion resistance, and the choice between 304 and 316 is decided by chlorides. Coastal sites, chlorinated washdown and chemical plants separate the two quickly.
Where 304 fails
Grade 304 resists atmospheric corrosion well in rural and urban environments. Within a few kilometres of the sea, salt spray deposits chlorides that break down the passive layer, and pitting appears — often on the underside of horizontal surfaces where salt accumulates. In a food plant washing with hypochlorite, the same happens within months.
Where 316 is the only answer
Grade 316 contains 2 to 3 % molybdenum, which stabilises the passive layer against chlorides. It is the minimum for coastal installations, for washdown with chlorinated water, and for any panel in a room where chlorine gas or hypochlorite is stored. The cost difference is roughly 30 to 40 % on the enclosure, which is small compared with replacing a panel after two years.
Finishing matters as much as grade
brushed finish with a roughness below 0.8 µm resists deposits better than a mill finish, and welds must be pickled and passivated or they corrode first. The coating note covers the painted alternative, and the custom control panel is available in either grade with the finish stated on the drawing.
