News
N

News

News

Drive Panels for Port Handling Equipment

Column: Company News    Time: 2025-01-04

Port handling equipment runs in salt air, with vibration from the crane structure and a duty cycle that stops only for maintenance. Panels built to a factory standard fail in this environment within a year.

What changed

Enclosures in 316 stainless rather than painted steel. All internal fixings in stainless, including the DIN rail screws. Cable entries through marine glands with a separate earth tag. Anti-condensation heaters on a thermostat, because the panel cools below dew point every night.

Drive side

The drives were specified with conformal-coated boards and mounted in a separate ventilated section with filtered air, so the control section stayed sealed. Braking resistors were mounted externally, on the crane structure, with a thermal switch wired back to the drive's fault input.

Service access

Every terminal accessible from the front with the panel mounted on the crane, no component requiring access from the rear. Labels were engraved traffolyte rather than printed, because printed labels do not survive ultraviolet and salt in an open structure. The brake resistor note covers the thermal design, and the custom control panel is built to this specification for marine and port applications.

More News