News
N

News

News

Stainless Panels for a Food Packing Hall

Column: Company News    Time: 2025-01-07

Food packing hall with a washdown routine at the end of every shift: 60 °C water, chlorinated detergent, hosed directly at the panels. The original painted enclosures lasted eighteen months before rust appeared at the door edges.

Specification change

The replacement panels were built in 304 stainless with a brushed finish, sloped tops so water runs off, and glands entering from below with drip loops. Door gaskets were silicone rather than nitrile, which resists the detergent. Hinges were stainless, and the door latches were the lift-and-turn type with no exposed screw heads.

Details that mattered

Welds were pickled and passivated, because an untreated weld on a washdown panel is where corrosion starts. The plinth was 300 mm high so the floor could be hosed underneath. Cable entries were fitted with blind plates, and every gland faced downward.

After two years

No corrosion at the door edges, no water inside on inspection, and two gaskets replaced after showing compression set — a consumable, not a failure. The stainless grade note explains why 304 was sufficient here, and the custom control panel is available in the same configuration.

More News