Planning Cable Entries Before the Enclosure Is Ordered
Gland plate or blind entries, bottom or top, spare capacity or none — the decision is cheap before the steel is cut and expensive afterwards.
Busbar and Short-Circuit Ratings in Distribution Boards
Continuous current is the number buyers check. Prospective short-circuit current is the one that decides whether the board survives a fault.
Layout Rules for PLC Panels: Power, Signal and Earth
Where the drive sits, where the analogue cable runs, and where the earth bar goes. Layout decides noise performance long before shielding does.
Powder Coating Line Rebuilt for Larger Cabinet Sections
The oven and the pretreatment tanks were resized to take a 2.2 m section in one pass, removing the two-part painting that used to leave a visible seam.
Cooling a Sealed Panel: Fans, Heat Exchangers or Air Conditioners
Three ways to remove the same watts, with very different maintenance loads. The choice follows from the ambient, the dirt and the duty cycle.
