News
N

News

News

Wireman Training Programme Enters Its Third Year

Column: Company News    Time: 2025-12-02

Wireman training programme finished its third intake this autumn. Six wiremen have completed it so far, and the first two are now running panels on their own with a final test signature.

Why we started it

Panel shops in this region hire experienced wiremen from each other. It works until the experienced ones are all employed, and then capacity is capped by a labour market that has nothing to do with our order book. The programme was an answer to that, and to a second problem: every wireman we hired from outside had to be retaught our numbering and labelling practice, which takes about three months.

How it is structured

Eighteen months, three stages, on the floor from week one but not on customer panels until stage two.

  • Stage 1 — practice boards, 4 months. Wiring exercises on a training board: DIN rail, contactors, relays, a small PLC, terminal strips. Each exercise is drawn, wired, tested and inspected. Mistakes cost nothing here.
  • Stage 2 — sub-assemblies, 8 months. Real work on internal modules that go into panels: 24 V distribution, relay interface plates, PLC sub-panels. Inspected by a senior wireman before fitting, and the inspector signs the module.
  • Stage 3 — full panels under review, 6 months. Complete panels, wired from the drawing, then tested and inspected as usual. Trainee signs their own test sheet with the supervisor countersigning.

Content is our own, based on the drawings we actually issue rather than on a generic syllabus. Reading a schematic is taught from our own sheets; terminal numbering is taught as destination-based because that is what the workshop uses.

What is taught that a course usually skips

  • Reading drawings for intent. Not just following lines, but recognising when the drawing cannot be right and stopping to ask.
  • Label discipline. Labelling as the wire is pulled, not after. We treat a missing label as a defect equal to a wrong wire.
  • Torque and tools. Torque values set with the wrong screwdriver are the wrong torque. Trainees use their own calibrated tool from stage two onward.
  • EMC basics. Why screens bond at the entry, why motor cables get their own duct. Taught as a reason, not as a rule.
  • Test discipline. The four tests, and why the sheet matters — including what a missing signature looks like from a customer's point of view.

What it costs and what it returns

Rough numbers, because they are the honest part: four months of stage one produces no saleable output. Training costs a wage plus about 30 per cent of a senior wireman's time in supervision during stage two.

Return shows up in year two. The two who have finished are productive at roughly 85 per cent of an experienced wireman's rate, and — more useful to us — they wire in our numbering practice without correction. Rework on their panels in the last six months was one item, a mislabelled core found at final test.

Retention is the other return. Of the six who started, five are still with us. Wiremen who are taught rather than told tend to stay, and in a workshop where the average tenure used to be under three years that matters more than the training cost.

What we would do differently

Stage one was too long. Four months on practice boards produced a trainee who could wire neatly and had never seen a real panel; motivation dropped around month three. The next intake moves to real sub-assemblies at month three, with the practice board kept for new exercises as they come up.

Second change: pair each trainee with one senior wireman for the whole programme, rather than rotating. The rotation was meant to spread knowledge; what it produced was six trainees who each learned six partial methods.

Where it is going

Next intake in spring, four places. Longer term the intent is that every panel leaving the workshop has been wired or inspected by someone who came through the programme, which is a slower way to build a team than hiring and the only one that produces wiremen who work the way we draw.

More News